V3 ECU Manager from MoTeC now available






MoTeC's new Version 3 software represents a major upgrade from our current ECU software. New features include:

• 4D Fuel and Ignition tables - for sophisticated engine mapping using any three channels

• Ref / Sync capture - allows the Crank and Cam signals to be captured at any RPM and displayed through a built in Oscilloscope function

• Engine Log Histograms - use 3 separate engine logs to record engine running time or any other channel

• Multiple Configurations - up to 4 different configuration files can be stored in the ECU for switching on the fly

• Plus many more

V3 software can be sent any of the 'hundred' series ECU - M400, M600, M800 and M880, allowing new and existing users to take advantage of all the new features.


REF/SYNC Capture
The Ref/Sync capture feature allows the Crank and Cam signals to be captured and displayed, providing a built in digital oscilloscope feature which is invaluable for checking the integrity of the Ref and Sync signals.


4D Tables
4D Fuel and Ignition tables allow sophisticated engine mapping based on any three channels, for example RPM, Throttle and MAP.


Engine Logs
V3 includes three engine histogram logs which can be configured to log any channel. For example one engine histogram might log engine RPM and another might log oil pressure. Also included is a tell-tale log for storing min and max values, plus an accumulated values store.


Plus..

Multiple Configurations: V3 allows up to four different configurations to be stored in the ECU and includes support for switching on the fly.

Selectable input channels for all tables. This feature allows extraordinary flexibility in how tables are used and even allows internal channels such as Fuel Pulse Width or Ignition Timing to be used as table inputs.

The axis sites can be varied independently for almost all tables allowing full optimisation for each table.

A completely revised input setup system includes adjustable filtering and diagnostic levels on all input channels.

Input data can be accepted from other devices connected via the CAN bus such as MOTEC Dash Loggers and PLM Lambda Meters (up to 12 PLMs can be connected), E888/816 Input/Output Expanders, or even another MOTEC ECU.

go to page2